Random Recipes

Hazard Ratings 624 S. Missouri, Indianapolis, IN 46225 ph: 317.684.7474 fx: 317.684.7484 www.jobsitesupply.com PRODUCT ESCRI TION JS Special Patch is a two-component, cement based, latex-modi fied repair mortar, specifically designed to provide fast and durable ramps, driveways, garage or warehouse floors, bridge decks, park ing structures. NSTRUCTIONS OR USE Surface Preparation General Traffic Surface Repairs: Saw-cut the repair area edges area to provide minimum depth. If reinforcement is exposed, clean ing. Bonding substrate should be clean, sound and moderately rough prior to repairing. Repairs: Saw-cut repair area edges to partial, minimum depth, but avoid cutting reinforcement. Remove loose, unsound or contami exposed reinforcement. Clean all corrosion products off exposed reinforcement by sand blasting or power wire brushing. and allow surface water to evaporate leaving a dry surface (SSD) immediately prior to installing JS Special Patch. Mixing: Pre-mix latex component prior to use. Before starting mixer, place JS Special Patch into mixer in the required proportions (7 pints of copolymer latex to 50 lb of powder). Start the mixer and slowly add the pre-blended dry JS Special Patch mortar into the mixer. Continue mixing for 1-2 minutes as necessary or until mixture is uniform and lump-free. Scrape down mixer sides as necessary. Do not mix for more than 3 minutes. Aggregate Extension: Use pea gravel/rock extension for all appli cations over 2” in thickness to reduce exotherm. Use a good qual Aggregates should be added only after mortar and latex is well mixed, then the mixing should be continued until the aggregate blends in evenly. Note: aggregate extension may diminish workability. Reduce aggregate quantity per batch if workability is not satisfactory for placement conditions. Working time is approximately 30 minutes @ 70ºF (21ºC). Both hot also be used where desired. Application: Place by filling area slightly overfull, then consolidate by strike-off surface with a straight edge. Delay final finishing until the slightly, then to shave surface down and texture as necessary using the lymer to surface of repair to increase wear resistance and durability. Clean-up: Tools and mixer can be cleaned with water before mixed Shelf Life: When stored in a controlled environment in accordance to Jobsite Supplyrecommendations and left in its original unopened characteristics for 12 months from date of manufacture. Storage: Keep from freezing, do not store in temperature above 120ºF. IMITATIONS/ ARNIN Contains hydraulic cement, calcium sulface, crystalline silica and other additives. Avoid breathing dust. Jobsite Supply recommends protection) when working with this product. Avoid eye contact or prolonged contact with skin. If eye contact occurs, wash immediately Wash affected skin areas with soap and water. Do not use for under NICAL ERVICES uct and technical support. PAC 50 lb bag and one-gallon jug of co-polymer 60 lb pail unit